WARNING: This is the _old_ Lustre wiki, and it is in the process of being retired. The information found here is all likely to be out of date. Please search the new wiki for more up to date information.

Difference between revisions of "Building Lustre Code"

From Obsolete Lustre Wiki
Jump to navigationJump to search
Line 35: Line 35:
 
</pre>
 
</pre>
  
5. To initiate a loopback-based Lustre mount for local testing, run:
+
==== Building and Testing Your Code ====
 +
Before you submit code for possible inclusion in Lustre, it must pass the ''acceptance-small'' acceptance test suite. For more details about the Lustre testing framework and ''acceptance-small'', see [[Testing Lustre Code]].
 +
 
 +
To initiate a loopback-based Lustre mount for local testing, run:
 
<pre>
 
<pre>
 
lustre/tests/llmount.sh
 
lustre/tests/llmount.sh
 
</pre>
 
</pre>
  
6. Test your code. Before you submit code, it must pass the ''acceptance-small'' acceptance test suite. For more details see [[Testing Lustre Code]].
+
To clean up the loopback mount (reverse the actions of the ''llmount.sh'' script), run <pre>
+
lustre/tests/llmountcleanup.sh
6. To clean up the loopback mount (reverse the actions of the ''llmount.sh'' script), run ''lustre/tests/llmountcleanup.sh'' .  Please
+
</pre>
see [[Running_Lustre_Tests_For_Developers]] for additional information.
 
[[Testing Lustre Code]]
 

Revision as of 10:36, 17 September 2009

The procedure on this page describes how to build and configure Lustre code in a development environment. It assumes that you have:

Configuring and Building Lustre

To configure and build Lustre, follow these steps:

1. Run the autogen script. The autogen script performs a few checks and then bootstraps the build system using the GNU automake and autoconf functions.

$ sh autogen.sh
Checking for a complete tree...
checking for automake-1.7 1.7.8... found 1.7.9
checking for autoconf 2.57... found 2.59
...
running autogen for liblustre...

2. Apply Lustre patches to your Linux kernel sources. For instructions, see Applying Lustre Patches to a Kernel.

3. Run configure to set up your system to compile the Lustre code. Configure performs extensive checks of the underlying system and kernel and then produces makefiles.

Note: Replace /path/to/linux with the path to your patched kernel source (for example, /tmp/kernels/linux-2.6.18-128.1.1)

$ ./configure --with-linux=/path/to/linux
checking build system type... i686-redhat-linux-gnu
checking host system type... i686-redhat-linux-gnu
checking target system type... i686-redhat-linux-gnu
...
LLCFLAGS: -g -Wall -fPIC

4. Type 'make' to build Lustre.

$ make
...

Building and Testing Your Code

Before you submit code for possible inclusion in Lustre, it must pass the acceptance-small acceptance test suite. For more details about the Lustre testing framework and acceptance-small, see Testing Lustre Code.

To initiate a loopback-based Lustre mount for local testing, run:

lustre/tests/llmount.sh

To clean up the loopback mount (reverse the actions of the llmount.sh script), run

lustre/tests/llmountcleanup.sh