WARNING: This is the _old_ Lustre wiki, and it is in the process of being retired. The information found here is all likely to be out of date. Please search the new wiki for more up to date information.
Upgrading to a New Version of Lustre: Difference between revisions
No edit summary |
|||
Line 18: | Line 18: | ||
== Prerequisites to Upgrading Lustre== | == Prerequisites to Upgrading Lustre== | ||
[[Are these procedures that must be completed before the upgrade is started?]] | [[Are these procedures that must be completed before the upgrade is started?]] [[Do they apply to any upgrade path?]] | ||
Remember the following points before upgrading Lustre. | Remember the following points before upgrading Lustre. |
Revision as of 10:29, 24 September 2009
Use the procedures in this chapter to upgrade Lustre 1.6.x to Lustre 1.8.0.
Note: In Lustre version 1.6 and later, the file system name (--fsname parameter) is limited to 8 characters so that it fits on the disk label.
Supported Upgrade and Downgrade Paths
For Lustre 1.8.x, the following upgrades are supported:
- Lustre 1.6.x to Lustre 1.8.0.
- One minor version to the next (for example, 1.8.0 > 1.8.x).
For Lustre 1.8.0, downgrades in the same ranges are supported.
- If you upgrade from Lustre 1.6.x > 1.8.0, you can downgrade to version 1.6.x.
- If you upgrade from one minor version to the next (for example Lustre 1.8.0 > 1.8.x), you can downgrade to an earlier minor version (e.g., version 1.8.x). Is this correctly stated?
Caution: A fresh installation of Lustre 1.8.x is not guaranteed to be downgradable to an earlier Lustre version.
For supported upgrade paths for earlier releases, see Upgrading from 1.4.6 and later to 1.6.
Prerequisites to Upgrading Lustre
Are these procedures that must be completed before the upgrade is started? Do they apply to any upgrade path?
Remember the following points before upgrading Lustre.
The MDT must be upgraded before the OSTs are upgraded. 1. Shut down lconf failover. 2. Install the new modules. 3. Run tunefs.lustre. 4. Mount startup.
A Lustre upgrade can be done across a failover pair. 1. On the backup server, install the new modules. 2. Shut down lconf failover. 3. On the new server, run tunefs.lustre. 4. On the new server, mount startup. 5. On the primary server, install the new modules.
Upgrade procedures
Which should be included here and which referred to in the manual?
Lustre Failover and Rolling Upgrades in OM.